Solenoid Valve Pneumatic WM1007 Waterjet Cutter Parts For Sale
Solenoid Valve Pneumatic WM1007 WaterWaterjet-Fiberglass-Good-Quality-5-Axis-Water-Jet-For-Sale-p.html target='_blank'>Jet Cutter Parts For Sale
The WM1007 is a 120 VAC pneumatic solenoid valve used in Waterjet Pump-Good-Quality-Natural-Materials-Water-Jet-Cutter-For-Sale-p.html target='_blank'>Intensifier Pump dump valve assemblies for rapid on/off control of high-pressure hydraulic oil. It is a direct-acting, 2-way/3-port poppet valve that remains closed without an electrical signal, venting port 3 on de-energization and directing supply air from port 1 to port 2 when energized.
Specifications
Electrical: 120 VAC coil
Air Ports: Supply in port 1, load out port 2, exhaust port 3
Weight: 0.224 lbs (≈ 102 g)
Body Material: Stainless steel and engineering polymers suitable for high-pressure pneumatic control
Installation & Maintenance
Electrical Connection: Wire the 120 VAC coil to a suitable power source with proper fusing.
Pneumatic Hookup: Connect clean, dry compressed air (80–100 PSIG) to port 1; run actuator line to port 2; cap or route exhaust from port 3 safely.
Bench Testing: Energize the coil to verify shift and air flow; de-energize to confirm venting action.
In-Machine Replacement: Isolate electrical and air supplies, remove the old valve, install WM1007 in the same orientation, then restore services and test under low pressure before full-pressure operation .
Specifications
Electrical: 120 VAC coil
Air Ports: Supply in port 1, load out port 2, exhaust port 3
Weight: 0.224 lbs (≈ 102 g)
Body Material: Stainless steel and engineering polymers suitable for high-pressure pneumatic control
Installation & Maintenance
Electrical Connection: Wire the 120 VAC coil to a suitable power source with proper fusing.
Pneumatic Hookup: Connect clean, dry compressed air (80–100 PSIG) to port 1; run actuator line to port 2; cap or route exhaust from port 3 safely.
Bench Testing: Energize the coil to verify shift and air flow; de-energize to confirm venting action.
In-Machine Replacement: Isolate electrical and air supplies, remove the old valve, install WM1007 in the same orientation, then restore services and test under low pressure before full-pressure operation .
